![]() Keep holding the button on until the LED on the transmitter AND the headset turn solid. While the LED is flashing on the USB dongle, press and hold the power button on the headset.Use a small paperclip to press and hold the re-pair button on the right of the USB dongle until the LED starts flashing rapidly.Connect the USB dongle to an active USB port of your console or PC.To re-pair the headset and the dongle you can follow these steps: How do I re-pair my dongle to my headset? Connect the usb transmitter to your Xbox One.ĭid you get the message saying the headset has been assigned to profile? If so turn your headset on and you are good to go. Reconnect the power cable to your Xbox and turn it on. The light on the transmitter will turn back on. Take a paper clip, push it inside the tiny hole on the left hand side of the transmitter and press and hold the button down until the light on the transmitter turns off. Turn your headset on and allow the headset to pair to the transmitter. IMPORTANT!!! If it does not say PC Version, do not try the steps bellow ***Click on that bubble and verify the device being installed says afterglow Anka/ Ag7 /Ag9 pc version. If it says something similar please continue with the steps below. You will get a bubble pop on the bottom right hand corner of your screen informing you that a device is being installed. Connect the usb transmitter to your PC. Once the Xbox is off disconnect the power supply. Turn off Xbox using the power button on the front of the console. ****Give these steps a try if you did not get the headset assigned message: Go into your messages create a new message, record a voice message and play the message back to yourself. Load up a game do you hear the game sound in the ear cups? The bottom dial is like a chat/game mixer. Is the headset listed there? If not follow the steps bellow ( marked by **** ) **If the lights are solid and you didn't get the message saying the headset has been assigned, go to your settings/device and accessories screen on your xbox one. Does the light on the transmitter and mic blink or is it a solid color? If the light is blinking you will need to pair the headset to the transmitter.(instructions located in manual) With the transmitter connected to your console and the headset on. ![]() On your screen you should get a message saying "headset assigned". Connect the usb transmitter to the usb port on the left side of your Xbox. After a 10 to 15 second wait, power on your Xbox and log into your profile. (You can also disconnect the power once your Xbox completely shuts off) Turn your Xbox one completely off by pressing and holding the power button on the front of the console. Turn the headset off and disconnect the usb transmitter from your Xbox one. Please check the following page for the part:Ĭlick Here: USB Transmitter AG7 for Xbox One For AG7 headsets having trouble being recognized by XBOX One.įirst, let’s verify that there are no cables connected to the headset and let’s make sure there are no cables or adapters connected to your Xbox one controller. These can replace your item whenever you lose your transmitter. We have several of the parts for the AG9+ headset available on our website. I have lost the USB transmitter for my headset, where can I proceed to receive a new transmitter? Over the ear cups bring users into an immersed experience with amazing sound quality.Comfortable adjustable headband for a personalized fit. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |